Job Listing Description

THIS JOB IS NO LONGER AVAILABLE. THIS IS ARCHIVAL INFORMATION.
NC Engineer II

Description:
NC Engineer II

Location: Savannah, GA
Pay Rate: DOE
Job Type: Long Term Contract
Schedule: First Shift

**Candidates must be a U.S. Citizen or Permanent Resident**

Unique Skills:
-Documented proficiency with NC Mill function in CATIA v5 is required.
-Must be proficient with CATIA v5 modeling and drafting, competent with computer systems and programs.
-Highly organized and capable of handling a fast paced, continuously changing environment when task are redirected.
-SmarTeam experience is preferred, but not required.
-Experience with aircraft interiors is a plus but not necessary.
-Understand engineering product structure (BOM)
-This position is for first shift, you may be asked to support other shifts as needed with notice.

Education and Experience Requirements
-Bachelor's Degree in Mechanical Engineering or a related curriculum required or equivalent combination of education and experience sufficient to successfully perform the essential functions of the job.
-Two (2) years of experience in machining, planning, tool design, or related manufacturing experience.

Other Requirements:
-Good verbal and written communication skills required.
-Must be able to read and interpret blueprints.
-Familiarity with various machining methods, technical writing, and computer use.
-Must possess good drafting, math, and geometry skills.
-Must be proficient with Catia modeling, drafting, and Catia NC Mill function.

Position Purpose:
-Under general supervision, perform activities related to numerical control (NC) programming, including machining methods, tooling concepts, and programs for NC milling machines and lathes.

Principle Duties and Responsibilities:
Essential Functions:
-Conduct a thorough analysis of engineering drawings, tool design drawings, and/or electronic models, to determine the optimal machining methods, selection of machine tool, and material cut size.
-Interact with planners, tool designers, engineering, and customers as required, to finalize plan.
-Develop cutter motion logic per operation sequence, selecting proper spindle speeds and feed rates.
-Perform a thorough check on all aspects of the program and verify cutter paths through the utilization of Vericut.
-Develop operator set-up sheets for numerical control machines.
-Develop flat pattern mylars and templates as required.
-Produce 2-D Catia tool drawings as required.

Additional Functions:
-May represent department in contacts with other departments, and may be required to coordinate efforts with vendors or customers.
-Assist in formulating Numerical Control policies, procedures, and specifications as required.
-Perform other duties as assigned.
 
Job Number: 18173
Job Location: Savannah, GA
Rate: DOE
Per Diem: Split Possible
Overtime: Possible
Duration: LT
Start Date: ASAP
Input Date: 08/12/2024
Firm Name: INCONEN CORPORATION
Attention: Patrick O'Neil
Address: 6133 BRISTOL PKWY STE 232
City, State: CULVER CITY, CA 90230
Phone: 310/410-1931
Fax Phone: 310/410-1751
Website: www.inconen.com

Previous Listing       Next Listing
Back to Abbreviated Search Results
Back to Complete Search Results
Back to Advanced Job Search

Phone: (425) 806-5200
Fax: (425) 806-5585
Email: staff@cjhunter.com
ContractJobHunter is a service of:
ContractJobHunter.com LLC
P.O. Box 3006, Bothell, WA 98041-3006, USA
Disclaimer
The content of this website is Copyright 2024 ContractJobHunter.com LLC
Terms of Use of ContractJobHunter
Refund Policy
Privacy Policy