Job Listing Description

THIS JOB IS NO LONGER AVAILABLE. THIS IS ARCHIVAL INFORMATION.
Engineering Designer II

Description:
Engineering Designer II

Location: Canoga Park, CA
Rate: $30.00 - $32.00/HR
3+ month contract

** Candidates must have experience with Creo and Geometric Dimensioning & Tolerancing (GD&T) **
** Candidates must be U.S. Citizens **
** Permanent residents are not eligible for this role **
** Dual citizens are not eligible for this role. Also, candidates with a current non-U.S. passport in addition to a U.S. passport are not acceptable **

Duties:
Design and Development Engineer - Must be able to specify valve type, valve trim configuration, material and seal packing’s for liquid rocket engine systems.

- Responsible for designing, developing and testing products including providing project time and cost estimate, product manufacturing and evaluation product for quality safety and cost.
- Applies research to the planning design Development and testing of valves, actuators and associated hardware
- Applies theories of heat and energy transfer to create practical solutions to technical problems
- Responsible for damage tolerance, durability, design modeling, coordination with analysis disciplines.
- Majority of work will be to develop and maintain valve layouts, designs/CAD models, and drawings using Creo2 graphics system for liquid engine hardware.

Activities: conceptual design creation, design layouts, GD&T application, tolerance analysis, systems design and integration, fabrication process identification, synthesis of higher level requirements to component level requirements. Conduct trade studies and develop schedules, test plans, component specifications and procedures.

Skills:
There are 3 different skill sets that they would accept:
1. Entry Level Designer
-Less that 5 years of technical experience.
-Experience with two or more of the following:
a. Creo
b Geometric Dimensioning and Tolerancing (also known as GD&T or ASME 14.5)
c. Windchill
d. Rocket
e. Valve
f. High Pressure
g. Cabling
h. Harness

OR

2. Engineering Designer II (Valve)
-Creo
-Geometric Dimensioning and Tolerancing (also known as GD&T or ASME 14.5)
-Experience with two or more of the following:
a. Windchill
b. Rocket
c. Combustion
d. Valve
e. High Pressure

OR

3. Engineering Designer II (Harness)
-Creo
-Geometric Dimensioning and Tolerancing (also known as GD&T or ASME 14.5)
-Experience with two or more of the following:
a. Windchill
b. Harness
c. Cable
d. Line Routing
e. Sensor

Education:
- BS degree in Engineering or equivalent. MS degree is desired.

Job Number: 6907
Job Location: Canoga Park, CA
Rate: $30.00 - $32.00/HR
Per Diem: Split Possible
Overtime: Possible
Duration: 3+ mos
Input Date: 11/14/2020

Firm Name: INCONEN CORPORATION
Attention: Patrick O'Neil
Address: 6133 BRISTOL PKWY STE 232
City, State: CULVER CITY, CA 90230
Phone: 310/410-1931
Fax Phone: 310/410-1751
Website: www.inconen.com

Previous Listing Next Listing
Back to Abbreviated Search Results
Back to Complete Search Results
Back to Advanced Job Search

Phone: (425) 806-5200
Fax: (425) 806-5585
Email: staff@cjhunter.com

ContractJobHunter is a service of:
ContractJobHunter.com LLC
P.O. Box 3006, Bothell, WA 98041-3006, USA Disclaimer
The content of this website is Copyright 2024 ContractJobHunter.com LLC