Job Listing Description

THIS JOB IS NO LONGER AVAILABLE. THIS IS ARCHIVAL INFORMATION.
Numerical Control (NC) Engineer I

Description:
Location: Savannah, GA
Rate: $50.00/HR
Duration: Long Term Contract
Shift: 4x10
Overtime: Possible (x1.5)
Per Diem Split: Yes (if eligible)

****MUST be a U.S. Citizen or Permanent Resident****

Required Skills:
- Familiar with or any experience in creating NC Products and NC Programs in CATIA V5 desired.
- Ability to navigate through Smarteam.
- Knowledgeable of machining composite materials such as aluminum and fiberglass honeycomb panels and their associated cutting tools.
- Familiar with using Vericut for proves out of programs.

Education and Experience Requirements:
- Bachelor's Degree in Mechanical Engineering or a related curriculum required or equivalent combination of education and experience sufficient to successfully perform the essential functions of the job.

Position Purpose:
- Under moderate supervision, perform duties related to numerical control (NC) programming, including machining methods, tooling concepts, and programs for NC milling machines and lathes.

Principle Duties and Responsibilities:
Essential Functions:
1. Conduct a thorough analysis of engineering drawings, tool design drawings, and/or electronic models, to determine the optimal machining methods, selection of machine tool, and material cut size.
2. Interact with planners, tool designers, engineering, and customers as required, to finalize plan.
3. Develop cutter motion logic per operation sequence, selecting proper spindle speeds and feed rates.
4. Perform a thorough check on all aspects of the program and verify cutter paths through the utilization of Vericut.
5. Develop operator's set-up sheets for numerical control machines.
6. Produce Catia 2-D tool drawings as required. Perform other duties as assigned.

Other Requirements:
1. Good verbal and written communication skills required.
2. Must be able to read and interpret blueprints.
3. Familiarity with various machining methods, technical writing, and computer use.
4. Must possess good drafting, math, and geometry skills.
5. Must have basic knowledge of Catia.

Job Number: 10640
Job Location: Savannah, GA
Rate: $50.00/HR
Per Diem: Split Possible
Overtime: Possible
Duration: LT
Input Date: 11/14/2020

Firm Name: INCONEN CORPORATION
Attention: Patrick O'Neil
Address: 6133 BRISTOL PKWY STE 232
City, State: CULVER CITY, CA 90230
Phone: 310/410-1931
Fax Phone: 310/410-1751
Website: www.inconen.com

Previous Listing Next Listing
Back to Abbreviated Search Results
Back to Complete Search Results
Back to Advanced Job Search

Phone: (425) 806-5200
Fax: (425) 806-5585
Email: staff@cjhunter.com

ContractJobHunter is a service of:
ContractJobHunter.com LLC
P.O. Box 3006, Bothell, WA 98041-3006, USA Disclaimer
The content of this website is Copyright 2024 ContractJobHunter.com LLC