Job Listing Description

NC Engineer II

Location: Savannah, GA
Rate: $52.50/HR
Duration: Long Term Contract
Overtime: Possible (x1.5)
Per Diem Split: Yes (if eligible)

****MUST be a U.S. Citizen or Permanent Resident****

Education and Experience Requirements:
1. Bachelor's Degree in Mechanical Engineering or a related curriculum required or equivalent combination of education and experience sufficient to successfully perform the essential functions of the job.
2. Three (3) years of machining, planning, tool design, or related manufacturing experience.

Position Purpose:
1. Under general supervision, perform activities related to numerical control (NC) programming, including machining methods, tooling concepts, and programs for NC milling machines and lathes.

Principle Duties and Responsibilities:
Essential Functions:
1. Conduct a thorough analysis of engineering drawings, tool design drawings, and/or electronic models, to determine the optimal machining methods, selection of machine tool, and material cut size.
2. Interact with planners, tool designers, engineering, and customers as required, to finalize plan.
3. Develop cutter motion logic per operation sequence, selecting proper spindle speeds and feed rates.
4. Perform a thorough check on all aspects of the program and verify cutter paths through the utilization of Vericut.
5. Develop operator set-up sheets for numerical control machines.
6. Develop flat pattern mylars and templates as required.
7. Produce 2-D Catia tool drawings as required.

Additional Functions:
1. May represent department in contacts with other departments, and may be required to coordinate efforts with vendors or customers.
2. Assist in formulating Numerical Control policies, procedures, and specifications as required.
3. Perform other duties as assigned.

Other Requirements:
1. Good verbal and written communication skills required.
2. Must be able to read and interpret blueprints.
3. Familiarity with various machining methods, technical writing, and computer use.
4. Must possess good drafting, math, and geometry skills.
5. Must be proficient with Catia modeling, drafting, and Catia NC Mill function.
Job Number: 11064
Job Location: Savannah, GA
Rate: $52.50/HR
Per Diem: Split Possible
Overtime: Possible
Duration: LT
Start Date: ASAP
Input Date: 06/10/2019
Last Updated: 08/06/2019
Attention: Patrick O'Neil
Address: 6133 BRISTOL PKWY STE 232
City, State: CULVER CITY, CA 90230
Phone: 310/410-1931
Fax Phone: 310/410-1751

Previous Listing       Next Listing
Back to Abbreviated Search Results
Back to Complete Search Results
Back to Advanced Job Search

Phone: (425) 806-5200
Fax: (425) 806-5585
ContractJobHunter is a service of:
C.E. Publications, Inc.
P.O. Box 3006, Bothell, WA 98041-3006, USA
The content of this website is Copyright 2020 C.E. Publications, Inc.